Pocket Door Hanging Instructions

Install the track according to the thickness of the header.

Pocket door hanging instructions. Use a pocket door wrench to turn the hanger a quarter of a turn at a time until the door is parallel with the jamb. Put the end brackets back on the cut end of the header. Once the frame is in place it s time for the pocket door installation. The other side of the pocket required the plywood pieces to be attached to the drywall before it was screwed to the pocket door wall studs.

If you have a gap at the bottom of the door that is causing rubbing towards the top of your door you can lower the door by adjusting the hanger that is positioned the furthest away from the door latch. Measure cut and install trim around the door starting with the top header trim piece and then the side jambs. Install hanging hardware on the top edge of the door according to the manufacturer s directions. Turn the header over and cut the metal track 1 3 8 shorter than the wood header.

Since the pocket door wall studs were normally 3 4 inch deep the 1 2 inch plywood never had a chance of touching the moving door. Pocketdoor diy carpentry please subscribe and hit the like button. Thanks for watching i reused the door and used a retro fit pocket door handle. At the length for your door cut the wood header only.

A pocket door is the perfect solution for closing off an open section of your home or office or adding a quick way to move from room to room where a wall currently exists. To adjust the length of the pocket door header before hanging it remove the end brackets. For the casing trim outside use finish nails just long enough to bite into the 2 x 4s longer nails might extend too far into the door chamber and scratch the door during opening and closing. It only took a few minutes of extra time to do this.

These doors disappear into the wall when opened rather than taking up space in one room or the other. Slide the wheel hangers into the track and hang the door on the two hangers.